• The Miyo Baby Hammock Co baby hammock has been successfully tested and approved to New Zealand and international safety standards.
• The recommended weight for our hammock is 0-15kg, but our hammock has been safety approved for up to 200kg. Please note, your common sense should be applied regarding the weight and length of your baby.

Safety Standard
BS EN 71-1-2001.

Hand wash all parts of the hammock with a mild, natural soap solution.
Allow to air dry.
DO NOT TUMBLE DRY
DO NOT DRYCLEAN
USE WARM IRON

Please read the following instructions and installation information carefully so your baby is always kept safe.

Note to consider before installing:

• Ensure that chains are high enough so that other children or objects cannot swing or reach into hammock, or undo domes.
• This is NOT a baby swing, although it has been designed to swing gently for baby’s comfort.
• Ensure baby has a clear space around where hammock is hung, so that baby does not bang against any objects eg. walls and doors.
• DO NOT hang hammock in doorway or closer than one metre to a wall. The hammock will block a doorway and baby may get knocked on side of door ie. walls and doors.
• Please ensure baby hammock is drilled securely into ceiling joist.
• Domes of hammock should always be fastened.

PARTS SUPPLIED WITH HAMMOCK:

How to install your Baby Hammock

STEP ONE:
Remove all parts from plastic protector bags.
Keep all plastic away from children.

Check that all parts are included (see check list above). If any parts are missing, please contact The Miyo Baby Hammock Co immediately. DO NOT INSTALL until you have all parts.

STEP TWO:
Using a 6mm drill bit drill hole into ceiling joists (solid timber ceiling frame not ceiling lining eg. plasterboard).

Screw hook into hole ensuring whole length of screw thread is in timber.

PLEASE ENSURE THAT THE HAMMOCK IS DRILLED INTO CEILING JOISTS.
FAILURE TO FOLLOW INSTRUCTIONS COULD RESULT IN SERIOUS BODILY HARM.

STEP THREE:
Put spring clip on bottom end of covered spring opposite end to chain.

(Spring cover and spring and chain should already be assembled. If not contact sarah@babyhammock.co.nz for assistance.)

STEP SIX:
Place mattress into body of hammock. Ensure that the top of the mattress is placed by the top seam, inside the body of the hammock. This enures that baby is in the correct position each time your baby is placed in the hammock.

STEP SEVEN:
Place wood separator halfway from the circle ring and the top edge of the hammock until all of the material fits snugly into each groove. Slide material into each of the grooves of wood.

Slide the wood up or down and straighten mattress until you are confident